Category: "Dollhouses"

Watson Mill - cutting holes

by brae  

Time to cut the window, door and ceiling openings.  I started with the simplest of the openings -- straight cuts.  I centered the lower front window under the windshaft and positioned it relative to the circle library for balance.   I cut the opening… more »

Watson Mill - circle library, part 5

by brae  

Continuing work on the circle library.  Since the plywood wall would stain different from the basswood and veneer, I needed to cover it.  That's why I wasn't especially careful in marking it up during the rest of the construction.  To make custom… more »

Watson Mill - circle library, part 4

by brae  

Continuing work on the circle library.  With the ladder moved to the front wall, I now have 8 3/4" of library wall space not including the two vertical end boards that will close it on the sides.  I marked the final position of the center circle.  This… more »

Watson Mill - circle library, part 2

by brae  

Continuing work on the circle library.   I added more cardboard around the circle supports to increase the depth to 3/4" since I determined my 5/8" depth was too narrow for the books I've been making.  I was able to use the existing supports since they… more »

Watson Mill - more on layouts

by brae  

I liked the dumbwaiter so much, I wanted it closer to the circle library so it could be more easily photographed.  I can't swap it with the ladder, since there would be no adjacent floor upstairs to step onto from the ladder.  This, my friends, is why… more »

1 2 4 ...6 ...7 8 9 10 11 12 ... 167