Bay window update, interior walls

by brae Email

The bay window is shaping up nicely, but I still have more changes in mind (of course).  I glued the exterior frames onto the walls and began the painting process to match the rest of the house.

I decided to pad the interior walls of the bay and adjacent walls.  I just find the connectors to be intrusive and a pain to wallpaper around.  This meant I had to do a bit of experimenting.

It was all made much easier by the fact that I had eliminated the side bay window and therefore had twice the parts for one bay window - minus the two exterior frames that I used to build the chimney.  But, it was the bay wall pieces that really mattered, and I had three extras, the exact number I needed.

I cut these wall pieces to fit inside the connectors on the interior.

I left a little wiggle room since any minor gaps will be covered by wallpaper.

The interior trim will then sit on top of these extra walls once I get to the interior.  To be honest, the plywood trim is pretty shoddy, so I'll likely end up cutting my own interior trim.  For the exterior, poor wood condition works well for this particular build, but the interior wouldn't be quite this bad.

I think the padded walls give this bay a much cleaner look.  The chair is an old Concord Miniatures piece that I repainted and reupholstered, borrowed from the Newport.

The adjacent walls are also padded using waste wood from the die cut frames.

This evens out that entire wall.  I'll pad the wall to the left, too, but it requires thinner wood.

I've heard from others who have built the Heritage and other Dura-Craft houses that once you get the windows and frames painted, the windows no longer work.  It's not a terrible disappointment to me that this might be the case since I don't plan to keep opening and closing the windows.  :D

Besides, the kit wood is not the best for this kind of wear and tear.  One of the windows needs to be glued shut simply because it's the only thing holding the assembly together.  :O  The other two I will glue in place partially open.  Who doesn't like a bit of fresh autumn air?  :D

7 comments

Comment from: Lucille [Visitor]
You did a super job and again so very well documented. You make it seem so easy when it isn't at all. I like the idea that you will be gluing a few windows halfway open. Perhaps you could have the curtains flying outside like it's a windy day. That would also be atmospheric! I'm so excited to see what your next step will be.
09/17/11 @ 12:29
Comment from: brae [Member] Email
Thanks, Lucille! The idea with the curtains is precisely what I have in mind! :yes:
09/17/11 @ 12:31
Comment from: Keli [Visitor]
When do you sleep?
09/17/11 @ 15:13
Comment from: brae [Member] Email
Sleep schmeep. :))
09/17/11 @ 18:07
Comment from: Irene [Visitor]
It looks pretty impressive so far and I like the idea of the curtains wafting in the breeze.
09/18/11 @ 03:09
Comment from: Lyssa [Visitor]
I love that you padded the walls. Makes for a much cleaner wall. I can just imagine all the combinations of autumn and kitchen smells. Yum!!!
09/18/11 @ 12:36
Comment from: brae [Member] Email
Thank you! :>>
09/19/11 @ 05:40